MUTOH ValueJet VJ-1204 User Manual page 58

Step 2 : Perform the initial adjust print.
•
Press the [Enter] key on the operation panel.
o
Notes
•
The length that media is fed (feeding length) for initial adjustment printing is normally set at 250 mm.
•
If you make the feeding length longer, the accuracy of the Media feed compensation improves.
If you want to change the feeding length, press the [+] key or [–] key and change the set value.
•
Press the [Enter] key on the operation panel.
o
o
No.
1 Feed length
2 Media feeding direction
o
•
After the initial adjustment printing, cut the media. See "Cutting media"
Step 3 : Measure the distance between two pluses in the initial adjustment print using a measurement
tool, such as a ruler.
Step 4 : Set up Initial Adjust Change.
• Press the [+] key or [–] key to select "PF2: Init.Adj.Change".
• Press the [Enter] key on the operation panel.
o The operation panel displays "Init: 250.0/250mm".
• Press the [+] key or [–] key and enter the measured value in step 3.
• Press the [Enter] key on the operation panel
o The initial adjustment value is saved.
o The operation panel displays "PF2: Init.Adj.Change".
Step 5 : Perform the Confirm Print.
• Press the [+] key or [–] key to select "PF3: Confirm Print".
• Press the [Enter] key on the operation panel.
The operation panel displays "Feed Length: 250 mm".
The operation panel displays "Feed Length: 250 mm".
The operation panel displays "Printing".
Start Initial adjustment printing.
When the initial adjustment printing is complete, the printer enters the normal
status
Name
58 AP-75740 – Rev 1.1 – 23/01/2007
User's Guide ValueJet 1204
Chapter 4: Handling the printer