Error Messages; Status Messages - MUTOH ValueJet VJ-1204 User Manual

6.2 ERROR MESSAGES

6.2.1 Status messages

This section describes the display during the printer operation.
When the product is operating correctly, the operation panel displays each operation status as below.
Message
Ready to Print
Paper End
Receiving [port*]
Converting [port*]
Under printing
Warming Up
Cleaning **%
Ink Refill **%
Washing
Moving Origin Pos.
Confirm Position →E
Remove Cassettes
** Initialling **
** Press 2sec. **
Insert CleaningCart.
Insert InkCassettes
Transport Mode
Media: Type ** OK?
Paper Initial
Cover Open
Lever Up
Layout Receiving
Remedy
Idling (Media is set).
Idling (Media is not set).
Receiving data. (* displays a port no.)
Analyzing data. (* displays a port no.)
Printing.
Warming up the heater.
Cleaning the head. Please wait a while.
Filling the ink. Please wait a while.
Cleaning the print head in the head cleaning process. Please wait a while.
The print head is moving to the original printing position on the Origin setup menu.
Please wait a while.
The print head is moving to the original printing position on the Origin setup menu.
Press the [Enter] key.
Cleaning the head.
Insert the cleaning cassette.
Initializing the setting on the Initialization menu. Please wait a while.
The [Cleaning] key or the [Nozzle Check] key is pressed for less than 2 seconds.
Press the key for more than 2 seconds again.
Filling the cleaning fluid
Insert the cleaning cassette.
Filling the ink.
Insert an ink cassette.
Preparing for transportation. Please wait a while.
Initializing the media.
Please wait a while.
(*** represents the setup media type.)
The front cover is open.
The media hold lever is positioned backward. Set the media.
After receiving print data, the printer is waiting for receiving the next data.
Displayed when the layout function is enabled.
115 AP-75740 – Rev 1.1 – 23/01/2007
User's Guide ValueJet 1204
Chapter 6: Troubleshooting