MUTOH ValueJet VJ-1204 User Manual page 104

(3) Replacement steps
To replace the waste fluid tank, follow the 5 steps below.
Step 1 : Verify that the plotter has been switched ON.
Step 2 : Pull out the waste fluid tank (1) as shown on the image below.
Result: No Waste fluid tank " will be displayed on the operation panel.
Notes
•
A used waste fluid tank should be put in a vinyl bag or bag used for this kind of waste. Disposal of a
waste fluid tank has to be done in compliance with the regulations and instructions of the local
authorities.
Step 3 : Install a new waste fluid tank (1) in the printer as shown on the image below.
Step 4 : Verify that the operation panel displays "Exchange Tank? No".
Step 5 : Select "Exchange Tank? Yes" and press the [Enter] key on the operation panel.
Notes
•
If the waste fluid tank is not replaced, press the [Enter] key on the operation panel with "Exchange
Tank? No" displayed.
No Name
1 Waste fluid box
No Name
1 Waste fluid tank
104
User's Guide ValueJet 1204
Chapter 4: Handling the printer
AP-75740 – Rev 1.1 – 23/01/2007