Usage; Repair And Maintenance - Razor powerrider 360 Owner's Manual

USAGE

Starting the PowerRider 360
To start the unit, turn the power switch "ON". Place both hands on the
handlebars and press the push button throttle.
Note: Keep both feet on the foot pegs when unit is in motion.

REPAIR AND MAINTENANCE

Turn power switch "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch off
Chain and Front Tire Replacement
Required Tools: Phillips screwdriver, 10 mm wrench, two (2) 8 mm wrenches, 14 mm wrench and 17 mm wrench
Disassembly
1
Using a Phillips screwdriver,
loosen the two (2) screws located
on each side of the motor cover/
chain guard. Use an 8 mm wrench
to hold the lock nuts that keep the
screws in place.
4
Using a 10 mm wrench, loosen
the brake cable anchor bolt and
disconnect the cable.
Throttle
Power
Switch
• Secure the unit under repair
• Exercise caution around
exposed parts
2
Using a Phillips screwdriver,
loosen the six (6) screws to remove
the motor cover/chain guard.
5
Using two (2) 8 mm wrenches,
remove the brake housing anchor
from the fork and brake plate. Keep
the bolt, washer and nuts together.
Stopping the PowerRider 360
To stop the unit, release the push button throttle and apply the brake until the
unit comes to a complete stop.
Brake
• Contact Razor customer service
if unsure about any repair or
maintenance
3
Remove the cable cap at the
end of the cable. (Do not lose.)
6
Using 14 mm and 17 mm
wrenches, loosen the axle locknuts.
Push down and remove the wheel
from the fork. Remove the chain
from the front sprocket.
8
Throttle