Charging Battery/Pre-Ride Checklist; Safety Gear - Razor powerrider 360 Owner's Manual

CHARGING THE BATTERY
Your PowerRider 360 may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.
• Initial charge time: 12 hours.
• Recharge time: up to 12 hours, even if the light turns
green. Recommended maximum charging time is
24 hours.
• Always charge the battery immediately after riding.
• Fully charge battery before storing for extended
periods of time.
• Unplug charger from the wall outlet when not in use.
• Failure to recharge battery periodically may result in a
battery that will not accept a charge.
Charger
Note: Make sure power is turned
OFF when unit is not in use. If
the power switch is left on for an
extended period of time, the battery
may reach a stage at which it will
no longer hold a charge.
Note: Charger may look different
than the pictures above.
PRE-RIDE CHECKLIST
Brake
Check the brakes for proper function. When you squeeze the
lever, the brake should provide positive braking action. Make
sure that brakes are not rubbing when the lever is released.
Tires/Wheels
Periodically inspect the tires for excess wear and regularly check
the tire pressure. Reinflate as necessary. Practice drift riding only
in wide open areas clear from curbs, parking blocks and other
obstacles. Impacting the wheels against any hard surface can
damage the wheels. Wheels are not covered under your limited
warranty.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken frames
are rare, it is possible for an aggressive rider to run into a curb
or object and wreck, bend or break a frame. Get in the habit of
inspecting your product on a regular basis.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
• Make sure power switch is turned OFF when unit
is not in use. If the power switch is left on for an
extended period of time, the battery may reach a stage
at which it will no longer hold a charge.
• To ensure long battery life, never store the product in
freezing or below freezing temperatures! Freezing will
permanently damage the battery.
• Run time: Up to 30 minutes of continuous ride time.
Run time may vary depending on riding conditions,
rider weight, climate and/or proper maintenance.
• Constant stopping and starting may shorten ride time.
• Battery life can vary depending on proper maintenance
and usage of the unit.
LED Light
1
Plug the charger into wall
outlet. The light on the charger
should be green.
Note: If green light (LED) does not
turn on, try a different outlet
2
Plug the charger into the charger
port on the product. Make sure the
power switch is in the OFF position.
The light on the charger should
turn red during charging. The light
will turn green when charging is
complete.
Hardware/Loose Parts
Before every ride, check all parts, such as nuts, bolts, cables,
fasteners, etc., to ensure they are secure and assembled
correctly. There should not be any unusual rattles or sounds from
loose parts or broken components. If the unit is damaged, do not
ride. Reference "Safety Warnings" on page 1 of this manual.

Safety Gear

Always wear proper protective gear, such as an approved safety
helmet. Elbow pads and kneepads are recommended. Always wear
athletic shoes (lace-up shoes with rubber soles) and keep shoelaces
tied and out of the way of the wheels, motor and drive system.
NEVER RIDE BAREFOOTED OR IN SANDALS.
Laws and Regulations
Always check and obey any local laws or regulations.
Insurance
Do not assume that your existing insurance policies necessarily
provide coverage for product use. Check with your insurance
company for information regarding insurance.
7
WARNING: Use ONLY with
the recommended charger. Batteries
are only to be charged under adult
supervision. The charger is not a toy.
Always disconnect the charger before
wiping down and/or cleaning the
PowerRider 360 with a damp cloth.
The charger supplied with the
PowerRider 360 should be regularly
examined for damage to the cord,
plug, enclosure and other parts.
In the event of such damage, the
PowerRider 360 must not be charged
until it has been repaired or replaced.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Note: If the charger gets warm during
regular use, this is a normal response
and is no cause for concern. If your
charger does not get warm during
use, it does not mean that it is not
working properly.
Wall outlet - Green (ready)
Wall outlet and unit - Red (charging)
Wall outlet and unit - Green (charged)
Note: Continue charging unit even
if light turns green prior to 12 hours.
WARNING: Battery charge
can deplete over time. Failure to
recharge the battery at least once a
month may result in a battery that
will no longer accept a charge.