Assembly And Set-Up - Razor powerrider 360 Owner's Manual

ASSEMBLY AND SET -UP
Attaching the Frame
Required Tools: Two (2) 5 mm Allen wrenches
1
Using two (2) 5 mm Allen
wrenches, remove the coupling
bolt on the end of the frame and
the coupling bolt in the middle of
the frame.
4
Securely tighten the (longer)
coupling bolt on the rear frame
using two (2) 5 mm Allen wrenches.
Attaching the Front Fork
Required Tools: 5 mm Allen wrench
1
Using a 5 mm Allen wrench,
remove the steering bolt from the
frame assembly.
4
Reinsert the steering bolt
and secure using a 5 mm
Allen wrench.
2
Remove and discard the plastic
insert. Note: The coupling bolt in
the middle of the frame is shorter.
5
Securely tighten the (shorter)
coupling bolt in the middle of
the frame using two (2) 5 mm
Allen wrenches.
2
Insert the front fork into the
frame assembly.
3
Insert the rear frame into the
frame assembly.
3
Be sure to properly align the
slot on headtube with the pin on
the front fork as shown.
4
WARNING: Failing to
properly tighten the steering
bolt that attaches the front fork
assembly to the frame assembly can
cause you to lose control and fall.