Before You Begin - Razor powerrider 360 Owner's Manual

BEFORE YOU BEGIN

Remove contents from box and check parts against parts diagram found on page 13. Remove the separators that
protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint or
dents that may have occurred during shipping. Because the PowerRider™ 360˚ was partially assembled and packed at
the factory there should not be any problems, even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Allow up to 15–20 minutes for assembly.
Required Tools
5 mm Allen wrench
(Included)
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
Push Button Throttle
Hand Brake
1. Front Fork
Foot Peg
Front Wheel Assembly
Valve Extender
(Located in the right
handlebar grip)
Charger
Seat
2. Frame
Rear Caster Wheels
3
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR POWERRIDER 360˚.
The PowerRider 360˚ has been
built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may not
be compatible and will void your
warranty.
PRODUCT I.D. CODE
1. Front Fork
2. Underneath Frame
3. Charger
4. UPC Side of Box (not shown)
Plastic Bag Contents:
• Charger
• Tools
• Owner's Manual