Timer Operation - Vivax ACP-12CH35AETI-B User Manual

Stop
ON/OFF button
Push this button again to stop the air conditioner.
Note: The fan speed cannot be adjusted when the unit is in AUTO and
DRY mode.
In DRY mode, due to the temperature difference between the setting temperature
and the actual indoor temperature, the unit will automatically operate in COOL or
FAN mode.

TIMER operation

SETTEM PERATURE( C)
AUTO F AN
HIGH
COOL
DRY M ED
HEAT LOW
ADJUST
ON /OFF
MODE
F ANSPEED
D IRE CTION
TIMER ON
SLEE P
/SW IN G
1
CLEAN
TIMER OFF
AIR
RE SE T LO CK
S ELF FOL LOW
LED
TURBO
C LEAN ME
DISPLAY
S ETTEMPERATUR E( C)
AUTO F AN
COOL
HI G H
DRY M ED
HEAT L OW
ADJUST
MODE ON /OFF
F ANSPE ED
DIR EC TI O N
TIMER ON
S LEE P
/SWI NG
CLEAN
TIMEROFF
AIR RE S ET LO CK
1
FOL LOW
SELF
L ED
C LEA N ME TURBO
DI S PLAY
To press the TIMER ON button can set the auto-on
time of the unit. To press the TIMER OFF button
can set the auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote
controller shows TIMER ON, the last Auto-on
setting time and the signal "h" will be shown on
the LCD display area. Now it is ready to
reset the Auto-on time to START the operation.
2. Push the TIMER ON button again to set desired
Auto-on time. Each time you press the button,
the time increases by half an hour between 0
and 10 hours and by one hour between 10 and
24 hours.
3. After setting the TIMER ON ,there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "h" will disappear and the set temperature
will re-appear on the LCD display window.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote
controller shows TIMER OFF, the last Auto-off
setting time and the signal "h" will be shown on
the LCD display area. Now it is ready to
reset the Auto-off time to START the operation.
2. Push the TIMER OFF button again to set desired
Auto-off time. Each time you press the button,
the time increases by half an hour between 0
and 10 hours and by one hour between 10 and
24 hours.
3. After setting the TIMER OFF ,there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "h" will disappear and the set temperature
will re-appear on the LCD display window.
8