Table of Contents
Advertisement
2. Configure PPTP Settings following the instructions below.
PPTP
MTU
VPN Start IP Address
Max VPN Clients
Auto DNS
DNS
CHAP Enable
MSCHAP Enable
MSCHAP2 Enable
MPP128 Enable
Proxy ARP Enable
NAT Enable
Add VPN / PPTP Rule
Click on [Add] tab. You will see the following screen.
Configure [Add PPTP] Settings following the instructions below.
Sequence Number
Rule Enable
User Name
Password
5.7
VPN IPSec
WAN failure detection works by detecting the presence of traffic on the 3G modem link. If the
link is idle for too long the router will attempt to ping a target IP address. If the ping does not
reply, the router assumes the link is down and attempts to fail over to Ethernet WAN link.
Choose Enable/Disable to enable/disable L2TP.
Enter MTU value. The default value is 1482 bytes.
Enter the VPN start IP address. The default value is 192.168.39.1.
Enter the max VPN clients.
Choose Enable/Disable to enable/disable Auto DNS.
Enter DNS server if you choose Disable for Auto DNS.
Choose Enable/Disable to enable/disable CHAP for VPN authentication.
Choose Enable/Disable to enable/disable MSCHAP for VPN authentication.
Choose Enable/Disable to enable/disable MSCHAP2 for VPN authentication.
Choose Enable/Disable to enable/disable MPP128 encryption.
Choose Enable/Disable to enable/disable Proxy ARP.
Choose Enable/Disable to enable/disable NAT.
This defines the sequence of the PPTP rules.
Enable/Disable this PPTP rule
Enter PPTP user name.
Enter PPTP password.
42
Advertisement
Table of Contents
