Restarting Automatically After A Power Failure; Adjusting The Angle Of The Panel; Power Saving Function - Epson Stylus Office BX600FW Basic Operation Manual

Restarting Automatically after a Power Failure

If the power supply fails while the
printer is in fax standby mode or
printing, it restarts automatically
when the power is reconnected. The
printer beeps for about two seconds.

Adjusting the Angle of the Panel

To lower or close the panel, unlock by pulling the lever on the rear until it
clicks, and then lower down. Simply lift the panel to raise it.

c
Do not put your hand inside
the printer until the print head
stopped moving.
Q
Restart is stopped if any of the
buttons on the control panel are
pressed before the LCD turns on.

Power Saving Function

After 13 minutes of inactivity, the screen turns black to save energy.
Press any button (except P On) to return the screen to its previous state.
Q
Depending on the circumstances
before the power failure occurred,
it may not restart. In this case, you
can restart by pressing P On.