Table of Contents
Advertisement
2-34 Command Line Interface Commands Reference
Ethernet Interface Static Client Address Translation Commands
Note:
The commands in this section are supported beginning with firmware version 8.5.
interface ethernet lan_interface_id scat enable [ yes | no ]
show interface ethernet lan_interface_id scat enable
These commands allow you to enable, disable, or show the status of static client address translation on the
specified LAN interface. This feature allows a statically addressed host whose address falls outside of the LAN
subnet(s) to simply plug in and get online without any manual configuration on either the host or the Motorola
®
Netopia
Router.
If scat enable is set to yes, statically addressed LAN hosts that have an address outside of LAN subnets will be
able to communicate via the Router's WAN interface to the Internet.
Supported static IP address values must fall outside of the Router's LAN subnet(s).
Ethernet Interface VRRP Commands
Note:
The commands in this section are supported beginning with firmware version 8.5.
A Virtual Router is a software abstraction consisting of a group of two or more hardware routers protecting one
or more IP addresses. One of the routers is designated as the Master, while the others are backups. VRRP is a
protocol that provides redundancy to routers within a local area network by allowing alternate paths for a PC
without changing the IP address or MAC address by which the PC knows its gateway.
A Virtual Router cannot be enabled unless it is populated with a Virtual ID and a Virtual IP address. The Virtual
Router index starts from 1 (one). Two virtual routers can be configured per LAN interface.
interface ethernet id ip vrrp vrouter id vrid [ 1... 255 ]
show interface ethernet id ip vrrp vrouter id vrid
These commands allow you to specify or display an ID (vrid) for the Virtual Router. vrid values may be in the
range 1 – 255.
interface ethernet id ip vrrp vrouter id vrip ip-addr
show interface ethernet id ip vrrp vrouter id vrip
These commands allow you to specify or display an IP address for the Virtual Router.
interface ethernet id ip vrrp vrouter id priority [ 1... 255 ]
show interface ethernet id ip vrrp vrouter id priority
These commands allow you to specify or display a priority for the Virtual Router. The default value is 100, if not
the owner of the virtual IP address. priority values may be in the range 1 – 255.
interface ethernet id ip vrrp vrouter id adv-intvl [ 1... 255 ]
show interface ethernet id ip vrrp vrouter id adv-intvl
These commands allow you to specify or display an advertisement interval in seconds. The default value is one
second; adv-intvl values may be in the range 1 – 255.
Advertisement
Table of Contents
