Netopia CLI 874 Cli Reference Manual page 137

ike phase1 { name | index } independent rekeys { yes | no }
show ike phase1 { name | index } independent rekeys
no ike phase1 { name | index } independent rekeys
ike phase1 { name | index } initial-contact { yes | no }
show ike phase1 { name | index } initial-contact
no ike phase1 { name | index } initial-contact
ike phase1 { name | index } negotiation { normal | initiate-only | respond-only }
show ike phase1 { name | index } negotiation
ike phase1 { name | index } pfs { yes | no }
show ike phase1 { name | index } pfs
no ike phase1 { name | index } pfs
ike phase1 { name | index } port policy { "strict" | "permissive" }
show ike phase1 { name | index } port policy
ike phase1 { name | index } sa lifetime { seconds | kbytes } { non-negative-integer | none }
show ike phase1 { name | index } sa lifetime [ { seconds | kbytes } ]
no ike phase1 { name | index } sa lifetime [ { seconds | kbytes } ]
ike phase1 { name | index } sa use-policy { new-sas-immediately | old-sas-until-expired }
show ike phase1 { name | index } sa use-policy
ike phase1 { name | index } vendor-id { yes | no }
show ike phase1 { name | index } vendor-id
no ike phase1 { name | index } vendor-id
ike phase1 { name | index } [ { yes | no } ]
no ike phase1 { name | index }
show ike phase1 { name | index }
These commands create, delete, or show the specified IKE Phase1 profile, which may be identified by index or
by name. The show version of this command displays the value yes if the specified IKE Phase 1 Profile exists,
and no otherwise.
show ike phase1 { name | index } id
This command displays the index of the specified IKE Phase1 profile. This command is useful only when
referring to a profile by name.
Global IPSec Configuration Commands
Motorola Netopia® Router CLI Commands 2-125