Applying Settings; Configuring System Log Settings; Setting The System Time - 3Com WL-560 User Manual

Applying Settings

Configuring System
Log Settings
Setting the System
Time
After you set the UART settings, network serial port settings or serial
telnet client settings, click Apply to apply them.
Under System Configuration, click System Log. The System Log page
appears where you can set syslog options.
Table 17 System Log Settings
Setting Description
Syslog Server The IP address of the syslog server on
the network
Syslog Port The port number that the syslog server
uses to received log data
Syslog Level Select the highest log level that you
want the Bridge to record. Options
include (from the highest to lowest):
Emergency - System is unusable
■
Alert - Action must be taken
■
immediately
Critical - Critical condition
■
Error - Error condition
■
Warning - Warning condition
■
Notice - Normal, but significant
■
condition
Informational - Informational
■
messages
Debug - Debug-level message
■
CLI Logging Select Enable to record all CLI
commands.
Web Audit Select Enable to record all operations
Logging executed on the Web interface.
Under System Configuration, click SNTP. The SNTP page appears where
you can set time relevant options.
There are two ways you can set the system time on the Bridge:
By setting the time manually
■
By enabling the built-in Simple Network Time Protocol (SNTP) client
■

Configuring System Log Settings

Default
0.0.0.0
514
Error
Enable
Enable
49