Table of Contents
Advertisement
Table 11 Wireless Network Page (continued)
Wireless LAN
Select Attach to any WLAN Service Area
Service Area
(ESSID) automatically to allow the Bridge
to associate with any access point without
specifying the ESSID. In this mode, the
Bridge uses the ESSID of the access point
with the best signal strength. This mode is
not available when the network mode is
Ad-hoc (Peer-to-Peer).
Select Specify the Wireless LAN Service
Area to allow the Bridge to associate only
with access points with the same service
area. You may enter the WLAN service
area name or select it from the list. You
must specify the WLAN service area when
the network mode is Ad-hoc
(Peer-to-Peer).
To maintain a wireless association, the
WLAN service area on a Bridge and the
access point with which it is associated
must match exactly. Therefore, if the
Bridge is set to Specify the WLAN Service
Area and you change the access point
WLAN service area, make sure to also
change the Bridge WLAN service area.
Setting Wireless Network Properties
33
Attach to any
WLAN Service
Area (ESSID)
automatically
Advertisement
Table of Contents
