Setting Wireless Network Properties - 3Com WL-560 User Manual

Setting Wireless
Network Properties
Table 10 IP Network Properties Page
Setting Description
IP Network Setting This setting allows you to change the IP
address of the device.
To let the device get an IP address
automatically from a DHCP server, select
Obtain an IP address automatically and
click Apply.
To specify an IP address, select Specify an IP
address, enter the IP address parameters in
the spaces provided, and click Apply.
IP Address When Specify an IP address is selected,
enter the IP address in the space provided,
and click Apply.
Subnet Mask When Specify an IP address is selected,
enter the Subnet Mask in the space
provided, and click Apply.
Gateway IP Address When Specify an IP address is selected,
enter the Gateway IP Address in the space
provided, and click Apply.
Under System Configuration, click Wireless Network. The Wireless
Network Properties page appears, where you can select different wireless
settings, as described in Table 11. When you are finished, click Apply.
The Bridge supports Dynamic and Static Turbo modes and boosts
throughput up to 108 Mbps.
The Dynamic Turbo mode allows automatic switching between normal and
turbo modes without modification by the user. The feature increases
throughput when bandwidth demands are high. When bandwidth demands
are low and at regular intervals, normal mode allows legacy connectivity and
new associations. The Dynamic Turbo mode connection between the Bridge
and the access point may turn to normal mode connection if another
wireless station associates with the access point in normal mode.
The Static Turbo mode operates by using two radio channels and does
not switch to normal mode. Static Turbo mode must be configured by the
user on both the access point and the station.

Setting Wireless Network Properties

31
Default
Obtain an IP
address
automatically
N/A
N/A
N/A