Wge101 Default Wireless Configuration Settings - NETGEAR WGE101 Reference Manual

WGE101 Default Wireless Configuration Settings

Note: If you are setting up a new wireless network, please set up the network and make sure it
works before adding the WGE101 Wireless Ethernet Bridge into the network.
You will need to identify the wireless configuration and security parameters already defined in
your wireless network.
Note: All NETGEAR, Inc. 802.11g and 802.11b wireless access products use similar factory
settings as the WGE101 and will work without any configuration changes.
The factory default settings for your WGE101 54 Mbps Wireless Ethernet Bridge are:
• Mode (Infrastructure or Ad-Hoc): Infrastructure
• Wireless network name Service Set Identification (SSID): Any
Note: Any means the bridge will connect to the access point or wireless router that has the
strongest signal. This may not be the closest access point or wireless router. For the WGE101
Wireless Ethernet Bridge to communicate with a specific wireless router or access point, both
devices must be configured with the same SSID.
• User ID: admin
• Password: password
• Authentication type: Auto
• WEP security: Disabled
• Country/Region: United States
Warning: Having the bridge set to the wrong country or region may result in the violation of
local laws.
WGE101-specific default settings:
• IP address: 192.168.0.201
• Protocol: Static
• Device name: netgearxxxx (where xxxx is the last 4 digits of the MAC address)
• Data rate: b/g combo
3