Enabling Wep Security - NETGEAR WGE101 Reference Manual

4. Click OK.
You'll see the Status page.
5. Click Change Password.
6. Type the old password in the Old
Password box.
7. Type a new password in the New
Password box.
8. Re-type the new password in the
Confirm Password box.
9. Click Apply.
10. If you are through making changes,
click Logout.

Enabling WEP Security

To prevent others from accessing your wireless network, you may enable WEP (Wired
Equivalent Privacy) security on your wireless network. If you do so, you'll need to enable WEP
security in all the devices. If you filled in the parameters on page 7, you may want to refer to
that page before making any configuration change.
Note: By default, WEP security is disabled.
1. Start your browser software.
2. Type http:// followed by the IP address for the bridge as the web address and press Enter
(or Return).
Note: The default value is
192.168.0.201. If you've set the bridge
to use DHCP, check the router table to
find out what the current address is for
the bridge.
3. Type admin as the User ID and
type the current password.
(password is the default.)
4. Click OK.
You'll see the Status page.
5. To change the WEP settings, click
Wireless Settings.
6. Select Web Data Encryption to enable WEP security.
14