Upgrading The Bridge - NETGEAR WGE101 Reference Manual

7. Select Open System or Shared as the Authentication Type.
8. Select 64 bits or 128 bits as the Key Length.
9. If the key is determined through software, type the phrase in the Passphrase box and click
Generate.
OR
If you entered a key manually for your wireless router or access point, select a Key and
type the hexadecimal values that are used with the wireless router or access point.
10. Click Apply.
11. If you are through making changes, click Logout.

Upgrading the Bridge

If there's a firmware upgrade, download the software from www.NETGEAR.com to your
computer and then use the browser-based configuration software to upgrade the bridge.
1. Start your browser software.
2. Type http:// followed by the IP address for the bridge as the web address and press Enter
(or Return).
Note: The default value is 192.168.0.201. If you've set the bridge to use DHCP, check the
router table to find out what the current address is for the bridge.
3. Type admin as the User ID and
type the current password.
(password is the default.)
4. Click OK.
You'll see the Status page.
5. To upgrade the bridge, click
Upgrade Firmware.
6. Click Browse and locate the
downloaded software.
7. Click Upload.
8. If you are through making changes,
click Logout.
15