Selecting A Specific Wireless Network; Changing The Bridge's Password - NETGEAR WGE101 Reference Manual

10. To use the bridge with a different computer or other Ethernet-enabled device, return to
Installing the WGE101 Bridge on page 4 to connect the bridge.

Selecting a Specific Wireless Network

On the Wireless Settings page, you can select a specific wireless network (SSID) and make
other configuration changes.
1. Start your browser software.
2. Type http:// followed by the bridge's IP address as the web address and press Enter (or
Return).
Note: The default value is 192.168.0.201. If you've set the bridge to use DHCP, check the
router table to find out what the current address is for the bridge.
3. Type admin as the User ID and
type the current password.
(password is the default password.)
4. Click OK.
You'll see the Status page.
5. Click Wireless Settings.
6. To connect to a specific wireless
router or access point, select the
correct one from the SSID (Existing
networks) list.
7. Click Apply.
8. Click OK.
9. Click Logout.
Note: You may also select the SSID on the Wireless Network Available page instead of the
Wireless Settings page.

Changing the Bridge's Password

1. Start your browser software.
2. Type http:// followed by the bridge's IP address as the web address and press Enter (or
Return).
Note: The default value is 192.168.0.201. If you've set the bridge to use DHCP, check the
router table to find out what the current address is for the bridge.
3. Type admin as the User ID and type the current password. (password is the default
password.)
13