NETGEAR WGE101 Reference Manual page 11

9. Click OK twice to close the Network control panel and save any changes.
10. If you made a change, restart the computer.
Note: After you've changed the settings on the bridge, you'll have to reset the TCP/IP
Properties: IP Address tab values back to their original state.
Windows 2000/XP
1. Right-click My Network Place and choose
Properties.
2. Double-click Local Area Network Connection and
click Properties.
3. Select Internet Protocol (TCP/IP) and click
Properties.
4. If Obtain an IP address automatically is selected,
select Use the following IP Address.
OR
If Use the following IP Address is selected, note
the current IP address.
5. Change the IP address to 192.168.0.230.
6. Click OK twice and click Close to save any
changes.
7. If you made a change, restart the computer.
Note: After you've changed the settings on the bridge, you'll have to reset the Internet Protocol
(TCP/IP) Properties dialog box back to its original state.
®
Mac OS 8.6 or 9.x
1. Choose Control Panels >TCP/IP from the
Apple ( ) menu.
2. If not already selected, select Ethernet in the
Connect via list.
3. If Manually isn't selected in the Configure list,
note the current selection and select Manually.
OR
If Manually is selected, note the current IP
address.
4. Change the IP address to 192.168.0.230 and
click the close box.
5. If asked, click Save.
9