Me101 Default Wireless Configuration Settings - NETGEAR ME101 User Manual

ME101 Default Wireless Configuration Settings

Note: If you are setting up a new wireless network, please set up the network and make sure it
works before adding the ME101 Wireless Ethernet Bridge into the network.
You will need to identify the wireless configuration and security parameters already defined in
your wireless network.
Note: All NETGEAR, Inc. 802.11b wireless access products use the same factory settings as the
ME101 and will work without any configuration changes.
The factory default settings for your ME101 802.11b Wireless Ethernet Bridge are:
• Mode (Infrastructure or Ad-Hoc): Infrastructure
• Wireless network name Service Set Identification (SSID): Any
Note: Any means the bridge will connect to the first access point or wireless router that
responds to the bridge's request for connection. This may not be the strongest signal or the
closest access point or router. For the ME101 Wireless Ethernet Bridge to communicate
with a specific wireless router or access point, both devices must be configured with the
same SSID.
• User ID: admin
• Password: password
• Authentication type: Auto
• WEP security: Disabled
• Country/Region: U.S.A.
Warning: Having the bridge set to the wrong country or region may result in the violation
of local laws.
• IP address: 192.168.0.200
Note: Each device in the network must have a unique IP address. If you have multiple
ME101 bridges in the network, only one can use the default address.
3