NETGEAR WGE101 Reference Manual page 8

WGR614 54 Mpbs
Wireless Router
WGE101 54 Mbps
Wireless Ethernet Bridge
5. Connect the provided Ethernet cable between the WGE101 Wireless Bridge and the
switch (or hub).
6. Connect each gaming console or other Ethernet-enabled device to the switch (or hub)
using an Ethernet cable.
7. Connect the switch's (or hub's) power adapter and plug that power adapter in to a power
outlet.
8. Connect the bridge's power adapter and plug the power adapter in to a power outlet.
The Power
9. After the Wireless LAN light
10. After turning on any gaming consoles, turn on any other Ethernet-enabled device(s).
If the bridge, switch, and the Ethernet-enabled devices are successfully connected, the
Network light
Note: If your setup works with the default settings, you don't need to configure the bridge
unless you need to change the Country/Region setting from the default setting (United States)
or you need to assign a unique IP address to subsequent WGE101 bridges. See page 12 for
information on configuring the bridge.
and Wireless LAN
will light up. This light flashes when there is network activity.
Cable
or DSL
modem
Fast Ethernet
Switch FS605
Ethernet-enabled
computer
lights should light up.
lights up, turn on any gaming console(s).
Gaming console or other
Ethernet-enabled device
6