Viewing A List Of Attached Devices - NETGEAR RANGEMAX WNDR3300 User Manual

NETGEAR RangeMax™ Dual Band Wireless-N Router WNDR3300 User Manual
Table 4-3. Router Statistics (continued)
Item Description
Status The link status of the port.
TxPkts The number of packets transmitted on this port since reset or manual clear.
RxPkts The number of packets received on this port since reset or manual clear.
Collisions The number of collisions on this port since reset or manual clear.
Tx B/s The current transmission (outbound) bandwidth used on the WAN and LAN ports.
Rx B/s The current reception (inbound) bandwidth used on the WAN and LAN ports.
Up Time The time elapsed since this port acquired the link.
Poll Interval The intervals at which the statistics are updated in this screen.
• To change the polling frequency, enter a time in seconds in the Poll Interval field, and click
Set Interval.
• To stop the polling entirely, click Stop.

Viewing a List of Attached Devices

The Attached Devices table lists all IP devices that the router has discovered on the local network.
From the main menu, under Maintenance, select Attached Devices to view the table.
Figure 4-7
For each device, the table shows the IP address, NetBIOS host name or device name (if available),
and the Ethernet MAC address. To force the router to look for attached devices, click Refresh.
Note: If the router is rebooted, the table data is lost until the router rediscovers the
devices.
4-8
v1.1, October 2008
Using Network Monitoring Tools