Viewing And Editing The Vpn Parameters - NETGEAR FVG318 Reference Manual

• Pre-Shared Key: 12345678 (in this example), must be the same at both VPN tunnel
endpoints
• Remote WAN IP address: 22.23.24.25 (in this example), must be unique at each VPN
tunnel endpoint
• Remote LAN IP Subnet
– IP Address: 172.23.9.1 (in this example), must be unique at each VPN tunnel endpoint
– Subnet Mask: 255.255.255.0 (in this example)
3. Log in to the FVL328 labeled Gateway B.
Log in at the default address of http://192.168.0.1 with the default user name of admin and
default password of password (or using whatever password and LAN address you have
chosen).
Note: Based on the network addresses used in this example, you would log in to the
LAN IP address of http://172.23.9.1 at Gateway B.
4. Repeat the process using the VPN Wizard to configure the FVL328 at Gateway B.
• Connection Name: Scenario_1 (in this example)
• Pre-Shared Key: 12345678 (in this example), must be the same at both VPN tunnel
endpoints
• Remote WAN IP address: 14.15.16.17 (in this example), must be unique at each VPN
tunnel endpoint
• Remote LAN IP Subnet
– IP Address: 10.5.6.1 (in this example), must be unique at each VPN tunnel endpoint
– Subnet Mask: 255.255.255.0 (in this example)
All traffic from the range of LAN IP addresses specified on FVG318 A and FVL328 B will now
flow over a secure VPN tunnel once the VPN tunnel is initiated (see
VPN Connections" on page

Viewing and Editing the VPN Parameters

The VPN Wizard sets up a VPN tunnel using the default parameters from the VPN Consortium
(VPNC).
• The Pre-Shared Key must be the same at both VPN tunnel endpoints.
VPN Configuration of NETGEAR FVG318
ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
C-12).
v1.0, September 2007
"Initiating and Checking the
C-11