Threading The Machine - Janome Skyline S7 Instruction Book

b c
n
m
,
z
c
r
t
t
v
u
y
n m ,
o
z x
v
x
e
w
b
!0

Threading the Machine

CAUTION:
Always make sure to press the lockout key to lockout
the machine before threading the machine.
Press the needle up/down button to raise the take-up
lever to the highest position.
Press the lockout key to lockout the machine. The
presser foot will go down and the upper thread tension
disks will open.
q Lockout key
Pass the thread in order z to ,.
q
z Hold the thread with both hands and pass the thread
into the guide slot w.
w Guide slot
x Be sure that the thread is pulled down under the
notch e and into the space below the guide slot as
shown.
e Notch
c Hold the thread with both hands and draw the thread
around the corner of the guide.
Firmly pull the thread toward you along the right
channel until the thread snaps.
r Corner of the guide
t Right channel
v Draw the thread down along the right channel and
around the bottom of the thread guide plate. Pull the
thread up along the left channel.
t Right channel
i
y Thread guide plate
u Left channel
b While holding the thread at the spool, firmly draw the
thread up and to the back of the take-up lever. Draw
the thread forward to slip it into the eye of the take-up
lever.
i Eye of the take-up lever
n Then pull the thread down along the left channel and
through the lower thread guide.
o Lower thread guide
m Slide the thread from the right of the needle bar thread
guide to the left.
!0 Needle bar thread guide
, Thread the needle with the needle threader (refer to
the next page).
13