Honda GC135 Owner's Manual page 4

2col_GC135_160_297x210_ORIZ_27lug09:297x210 (303x216) 25/09/09 13:04 Pagina 4
REFUELING
Recommended Fuel
Unleaded gasoline
Research octane rating 91 or higher
Pump octane rating 86 or higher
This engine is certified to operate on unleaded gasoline with a
research octane rating of 91 or higher (a pump octane rating of 86
or higher).
Refuel in a well ventilated area with the engine stopped. If the
engine has been running, allow it to cool first. Never refuel the
engine inside a building where gasoline fumes may reach flames
or sparks.
You may use unleaded gasoline containing no more than 10%
ethanol (E10) or 5% methanol by volume. In addition, methanol
must contain cosolvents and corrosion inhibitors. Use of fuels
with content of ethanol or methanol greater than shown above
may cause starting and/or performance problems. It may also
damage metal, rubber, and plastic parts of the fuel system. Engine
damage or performance problems that result from using a fuel
with percentages of ethanol or methanol greater than shown
above are not covered under the Warranty.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when refueling.
Stop the engine and keep heat, sparks, and flame
away.
Refuel only outdoors.
Wipe up spills immediately.
Fuel can damage paint and some types of plastic. Be careful not to
spill fuel when filling your fuel tank. Damage caused by spilled
fuel is not covered under the Warranty.
Never use stale or contaminated gasoline or an oil/gasoline
mixture. Avoid getting dirt or water in the fuel tank.
Refer to the instructions provided with the equipment powered by
this engine for refuelling.
4
1. With the engine stopped and on a level surface, remove the fuel
tank cap and check the fuel level. Refill the tank if the fuel level is
low.
2. Add fuel to the upper limit mark of the fuel tank. Wipe up spilled
fuel before starting the engine.
F U E L T A N K C A P U P P E R I L M T I
3. Refuel carefully to avoid spilling fuel. Do not overfill the fuel
tank (there should be no fuel above the upper limit mark). It may
be necessary to lower the fuel level depending on operating
conditions. After refueling, tighten the fuel tank cap securely.
Keep gasoline away from appliance pilot lights, barbecues,
electric appliances, power tools, etc.
Spilled fuel is not only a fire hazard, it causes environmental
damage. Wipe up spills immediately.
ENGINE OIL
Oil is a major factor affecting performance and service life.
Use 4-stroke automotive detergent oil.
Recommended Oil
Use 4-stroke motor oil that meets or exceeds the requirements for
M A R K API service category SE or later (or equivalent). Always check the
API service label on the oil container to be sure it includes the
letters SE or later (or equivalent).
AMBIENT TEMPERATURE
SAE 10W-30 is recommended for general use. Other viscosities
shown in the chart may be used when the average temperature in
your area is within the indicated range.
Oil Level Check
1. Remove the oil filler cap and check the oil level.
2. If the level is low, add the recommended oil to the upper limit
(bottom edge of the oil fill hole).
OIL FILLER CAP UPPER LIMIT
OIL FILL HOLE
(bottom edge)
3. Install the oil filler cap.
Running the engine with a low oil level can cause engine damage.
This type of damage is not covered under the Warranty.
The Oil Alert system (applicable types) will automatically stop the
engine before the oil level falls below the safe limit. However, to
avoid the inconvenience of an unexpected shutdown, always
check the engine oil level before startup.
ENGLISH
Oil Change
Drain the used oil when the engine is warm. Warm oil drains
quickly and completely.
1. Place a suitable container below the engine to catch the used oil,
then remove the oil filler cap, oil drain plug and washer.
2. Allow the used oil to drain completely, then reinstall the oil drain
plug and a new washer, and tighten the oil drain plug securely.
3. With the engine in a level position, fill with the recommended oil
to the upper limit (bottom edge of the oil fill hole).
Engine oil capacity: 0.58 L (0.51 lmp qt)
4. Install the oil filler cap and tighten securely.
OIL FILLER CAP
WASHER
OIL DRAIN PLUG
Wash your hands with soap and water after handling used oil.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take it in a sealed container
to your local service station for reclamation. Do not throw it in the
trash, pour it on the ground, or pour it down a drain.