Removing The Door Latch Assembly - KitchenAid KEBK171SSS Technical Education

REMOVING THE DOOR LATCH ASSEMBLY

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug oven or disconnect power.
WARNING
Excessive Weight Hazard
Use two or more people to move and
install oven.
Failure to do so can result in back or
other injury.
2. Remove the oven from its mounting location
(see "Installation Information" in Section 2)
and pull it forward so that you can access
the top cover.
3. Remove the six screws from the top cover
and remove conduit screw and remove
Screws (3 of 6)
Top Cover
4. Unhook and remove the AC wiring conduit
connector from the back of the cover
5. Open the oven door, remove the two flat-
head screws from the bottom of the control
panel frame, and remove the frame.
Control Panel Frame Screws
6. Remove the four screws from the front
control subpanel, remove the subpanel
assembly, and lay it on top of the oven.
Front Subpanel Screws
7. Remove the four screws from the
oven air vent and remove the vent.
Continued on the next page.
4-7
Conduit Screw
Air Vent Screws