Press a Base Cap (70) into the Base
(74).
Make
sure that the Upright Grommet
(73) is
pressed
into the square
h(!le in the Base (74).
J
70
Square
Hole
4.
identify the Right Upright (76), which is marked
"Right,"
Have
a second person
hold the Right
Upright
near the Base (74).
See the inset
drawing.
Tie the wire "tie in the
Right Updght
(76) securely
around the end of
the Upright
Wire (63). Then, insert the Upright
Wire into the lower end of the Right Upright
as
you pull the other end of the wire tie through
the
Right Upright.
4