Warnings; Assembly; Packing List - Husky H1504FK-R Operator's Manual

WARNING
Do not use any type of reactive gases, including, but not limited to, oxygen and combustible gases, as
a power source. Use filtered, lubricated, regulated compressed air only. Use or a reactive gas instead of
compressed air may cause the tool to explode which will cause death or serious personal injury.
Never use gasoline or other flammable liquids to clean the tool. Never use the tool in the presence of
flammable liquids or gases. Vapours could ignite by a spark and cause an explosion which will result in death
or serious personal injury.
Use clean, dry, regulated, compressed air at 70-115 psi. Do not connect tool to pressure which
potentially exceeds 120 psi.
Always remain in a firmly balanced position when using or handling the tool.
Do not remove, tamper with, or otherwise cause the Work Contact Element (WCE) or trigger to
become inoperable. Do not operate any tool which has been modified in a like fashion. Death or
serious personal injury could result.
Do not touch the trigger unless driving fasteners. Never attach air line to tool or carry tool while touching
the trigger. The tool could eject a fastener which will result in death or serious personal injury.
Always fit tool with a fitting or hose coupling on or near the tool in such a manner that all compressed air in
the tool is discharged at the time the fitting or hose coupling is disconnected. Do not use a check valve or any
other fitting which allows air to remain in the tool. Death or serious personal injury could occur.
Always disconnect the tool from the power source when unattended, performing any maintenance or repair,
clearing a jam, or moving the tool to new location. Always reconnect the air line BEFORE loading any fastener.
Do not load the tool with fastener when either the trigger is depressed or the Work Contact Element (WCE) is
engaged. The tool could eject a fastener causing death or serious personal injury.
Never carry the tool by air hose or pull the hose to move the tool or a compressor. Keep hoses
away from heat, oil and sharp edges. Replace any hose that is damaged, weak or worn. Personal
injury or tool damage could occur.
Do not drive a fastener on top of other fasteners. The fastener could glance and cause death or
serious puncture wound.
Always check that the Work Contact Element (WCE) is operating properly. A fastener could
accidentally be driven if the WCE is not working properly. Personal injury may occur.

PACKING LIST

Framing Nailer (1)
Allen wrenches (3)
Bottle of oil (1)
Red trigger (1)
1/4" NPT male plug (1)
Set of Nails (1)
Safety Goggles (1)
Operator's Manual (1)

WARNINGS

EXPLANATION

ASSEMBLY

Framing Nailer
Safety Goggles
Set of Nails
23
Oil bottle
¼" NPT Male Plug
Allen wrenches
Red Trigger