Loading The Nailer; Unloading The Nailer - Husky H1504FK-R Operator's Manual

MODE CONVERSION
To convert the tool from one mode to the other (see Fig. 3):
1. Remove o-ring (A) on the side of trigger pin (B).
2. Remove trigger pin (B), trigger (C), and trigger spring (D).
3. Switch out only the trigger (C).
4. Replace trigger spring (D), trigger (C), trigger pin (B), and
o-ring (A).
Do not attempt to modify the trigger components in any
manner and do not attempt to use any other trigger
components other than those intended for this tool.

LOADING THE NAILER

1) After reading and understanding this entire manual,
connect the tool to air supply (Fig. 4).
- Always connect tool to air supply before loading
fasteners (Fig. 4).
- Do not load fasteners with trigger or safety
depressed.
- Only use the right and quality fasteners.
- Operator and others in work area must wear safety
glasses with side shields.
- Never use a tool that is leaking air, has missing or
damaged parts, or requires repair.
2) Pull follower (A) all the way to the rear, until it catches
(Fig. 5).
3) Orient a strip of nails with points down (Fig. 6), and
drop into the magazine. Slide fasteners forwards to the
front of the magazine. The magazine can be load with
two full strips of fastener.
4) Pull back on the follower (A) and press the release
lever (D) (Fig. 7), and while pressing the lever (D),
release the follower (A) to slide forward against nails.
5) Adjust directional exhaust deflector (B) (Fig. 8), so
that the exhaust air blast will be directed away from
the operator: loosen deflector retaining screw (C) (Fig.
8), rotate deflector to desired position for the current
application and tighten retaining screw.

UNLOADING THE NAILER

Always unload all fasteners before removing tool from
service. Unloading is the reverse of loading: always
disconnect the air hose before unloading.
WARNING:
Keep fingers away from trigger when not driving
fasteners to avoid accidental firing.
WARNING:
Disconnect tool from air supply before performing
maintenance, clearing a jammed fastener, leaving work
area, moving tool to another location, or handling the
tool to another person.
OPERATION
Trigger
Pin (B)
26
Trigger spring (D)
O-Ring (A)
Trigger (C)
Fig. 4
A
Fig. 6
A
B
C
Fig. 8
Fig. 3
D
Fig. 5
D
1
2
Fig. 7