Using The Foot Switch (Vox Vfs5); Operations In User Program Mode; Foot Switch Operations In Preset Or Manual Modes; Connecting To A Computer Via Usb - Vox VT100X Owner's Manual

Using the foot switch (VOX VFS5)

If an optional VOX VFS5
foot switch (sold separately)
is connected to the FOOT
SW jack on the amp, you
can use your foot to switch
the bank and channel as well as turn on/off the effect.
You must connect or disconnect the foot switch while the power is
off. Malfunctions or damage may occur if you connect or disconnect
the foot switch while the power is on.
Do not press two or more foot switches simultaneously. Doing so
may cause malfunctions.

Operations in user program mode

Switching the bank and channel (BANK and CH1 to CH4 switches)
Press a switch on the VFS5 to change the bank or channel.
If you press a VFS5 switch in preset programs mode or manual
mode, the amp will not switch to user program mode. In addition, a
program cannot be saved by holding down a channel (CH1 to CH4)
switch on the VFS5.
Use of the top panel will not be reflected by the VFS5's LEDs.
Tap to set the speed/time (CH1 to CH4 switches)
Press the switch with the same number as the selected channel to set the
speed and time for the PEDAL2 effect. The interval between two presses
of the switch will be set as the speed and time.
Specifying the VFS5 operation
Hold down the switch with the same number as the selected channel for
at least 3 seconds to perform the same operation as in preset programs
mode or manual mode; the effect selection buttons blink briefly. To
return to the previous operation, hold down the CH3 switch for at least 3
seconds. (The BANK and channel buttons blink briefly.)

Foot switch operations in Preset or Manual modes

Tap to set the speed/time (CH3 switch)
Press the CH3 switch on the VFS5 to set the speed and time for the
PEDAL2 effect. The interval between two presses of the switch will be
set as the speed and time.
Effect on/off (CH1, 2, 4 switches)
Press the CH1, CH2 or CH4 switch on the VFS5 to switch on/off the
corresponding PEDAL1, PEDAL2 or REVERB effect.

Connecting to a computer via USB

By connecting the amp to a computer using a commercially available
USB cable, the Editor/Librarian software on the computer can be used to
manage programs and customize amps/effects.
The VT100X can also be connected to an iOS device (iPad or iPhone) by
using the Apple USB camera adapter.
Install a USB-MIDI driver in order to use the Editor/Librarian
Tip
software on the computer. Download the newest versions of the
drivers and software from the VOX website ( www.voxamps.com ).
For details on using the Editor/Librarian software, refer to the
Tip
documentation included with the software.

About the amp models and effect types

This section provides details on the amp models, the various types of
PEDAL1, PEDAL2 and REVERB effects as well as noise reduction.
Unnatural distortion may occur, depending on the amplifier and
effector settings. If this occurs, adjust the amp and effect parameters.
If a parameter not available on the top panel is changed in the
Editor/Librarian software, the tone may become quite different from
the original amp model or effect type.
- 9 -
VT100X Owner's manual