Reverb Effects; Noise Reduction - Vox VT100X Owner's Manual

4 . DELAY
This models an acclaimed analog tape echo. Originally, echo was created
by a tape head, and the delay time was specified by changing the speed
of the motor.
Button/Knob Parameter
TAP TIME Adjusts the delay time.
VALUE 1 LEVEL Adjusts the mix amount of the delay sound.
VALUE 2 FEEDBACK Adjusts the amount of feedback.

REVERB effects

Adjust the mix amount of the reverb sound with the VALUE 1 knob and
the reverb duration with the VALUE 2 knob.
1 . ROOM
This reverb type simulates a typical room that contains numerous early
reflections.
2 . SPRING
This simulates the spring reverb that's built into many guitar amps.
3 . HALL
This models the reverberation and echo of a large concert hall.
4 . PLATE
This models a classic plate reverb unit usually found in recording studios.

Noise reduction

This applies a noise-reducing effect.
As with amps and effects, noise reduction must be set for each
program. If, while changing settings in the preset programs mode
or the user program mode, you switch to another program or to
manual mode or turn off the amp before saving the settings, the
changes that you made will be lost.
When the amp model is changed, the noise reduction setting is
returned to the standard setting for each amp.
Effect
- 12 -
1. Hold down the TAP button to bypass the effects (the tuner function
is turned on).
2. Turn the VALUE 1 knob to adjust the sensitivity of noise reduction.
Turn the knob to the right to increase the noise-reducing effect. When
this knob is fully turned to the left, noise reduction is turned off.
Depending on your guitar, increasing the sensitivity of noise
reduction too much may cause interruptions in the sound.
3. Press the TAP button to cancel bypass.
Global noise reduction setting
The noise level changes depending on the guitar being used, the power
supply and other external factors. When the operating environment
is changed, overall adjustments can be made while maintaining the
different sensitivities specified for each program.
This setting does not affect programs in which noise reduction has
been turned off.
1. While holding down the TAP button, turn on the amp.
The illumination of the effect selection buttons shows the current
setting.
2. Press the TAP button or turn the VALUE 1 knob to change the setting.
3. Wait without performing any operation for a few seconds. The setting
is applied, and the amp automatically returns to normal operation.
Low
Medium
High