Saving A Program; Restoring The Factory Settings; Using The Tuner - Vox VT100X Owner's Manual

Saving a program

After adjusting the various knobs and buttons on the top panel to create
your desired sound, it can be saved (written) as a user program.
When saving programs to channels within the same bank, start the
Tip
procedure from step 3.
1. Hold down the BANK button for at least 0.5 second. The BANK button blinks.
2. Press the BANK button to select the bank where the program will be saved.
To cancel the write operation, press the TAP button.
Tip
3. Hold down the channel button of the save location for at least 2 seconds
(until the button changes from blinking to lit). The program is saved to
the channel, and the bank and channel for the save location are selected.
Any program previously saved at that location is overwritten.
In other words, the program previously saved at the location
selected in step 3 is erased.
The bypass setting of the effect and the POWER LEVEL setting
are not saved with the program.
If, while creating a sound in the preset programs mode or the
user program mode, you switch to another program or to manual
mode or turn off the amp before saving the sound that you are
creating, the changes that you made will be lost.

Restoring the factory settings

Here's how to restore all settings of the VT100X to their factory-set state.
When this operation is done, all programs saved to channels as well
as all settings, such as custom amp settings stored from the Editor/
Librarian software, will be reset to the factory defaults.
1. Turn off the power.
2. While holding down the CH1 and CH4 buttons, turn on the amp. After
the BANK and channel buttons blink, release the pressed buttons.
If you decide to cancel initialization at this point, press the TAP
Tip
button.
3. Hold down the BANK button for at least 2 seconds (until the button
changes from blinking to lit).
After the BANK and channel buttons change from blinking to lit,
initialization begins. Initialization is completed after about 1 to 2
seconds, and the amp enters the preset programs mode.
Never turn off the power while initialization is in progress.
The tuner function allows you to easily tune a guitar that's connected to
the INPUT jack.
1. Hold down the TAP button for
at least 1 second.
All effects, except noise
reduction, are bypassed, and the
tuner function is turned on.
2. Play any open string on the guitar.
Be careful not to play any of the other strings.
3. Roughly tune the string until
the button (BANK and channel
buttons) indicating the string that
was played lights up.
4. While checking the effect
selection buttons, correctly
tune the guitar.
5. Press the TAP button to turn
off the tuner function and
cancel bypass.
- 8 -

Using the tuner

Sharp
Slightly sharp
In tune
Slightly flat
Flat