Installing Or Replacing Sim Card - VeriFone VX 520-G Installation Manual

NOTE
Installing or
Replacing SIM
Card
6
Install an MSAM card by carefully sliding it into the slot until it is fully inserted.
Figure 13 Installing an MSAM Card in a VX 520-G Terminal
Before inserting the MSAM card, position it as shown in
gold contacts facing down. The cardholder connector base has an image
resembling the notched corner of an MSAM card to ensure the card is positioned
correctly.
7
Close the MSAM cardholder panel, and then replace the terminal rear cover.
The VX 520 GPRS terminal supports the installation of a SIM (Subscriber Identity
Module) card. Use the following procedure to replace or install a SIM card.
1
Place the terminal upside down on a soft, clean surface to protect the display
from scratches.
2
Remove the battery.
Figure 14 Removing the Smart Battery
3
After removing the battery, you will see the SIM compartment.
T
ERMINAL

Installing or Replacing SIM Card

Figure 13, with the card's
VX 520-G I G
NSTALLATION UIDE
S
ETUP
23