Connecting Optional Devices; Optional Device Connections - VeriFone VX 520-G Installation Manual

T S
ERMINAL ETUP

Connecting Optional Devices

Connecting
Optional
Devices
CAUTION
Optional Device
Connections
Connecting a
PIN Pad to the
VX 520-G
NOTE
24
VX 520-G I
NSTALLATION
4
Insert the SIM into the cardholder.
Figure 15 Inserting SIM Card
5
Install the battery.
The VX 520-G terminal supports some peripheral devices designed for use with
electronic point-of-sale terminals.
Before connecting any peripheral device, remove the power cord from the
terminal and ensure that the green indicator LED is not lit. Reconnect the power
cord only after you are finished connecting the peripheral device(s). For complete
information about peripheral installation and use, refer to the user documentation
supplied with those devices.
Different terminals support different devices, so for more information about
optional devices, please contact your VeriFone distributor.
The VX 520-G terminal has a port that can operate either as a PIN pad port or an
RS-232 port, depending on the power source available.
Use the following procedures to connect a PIN pad or smart card reader.
When the VX 520-G terminal is powered via the corded power supply, the
terminal provides 4.0 A at 9.3V DC. This power will drive most VeriFone
accessories. Contact your local VeriFone representative for more information.
1
Remove the VX 520-G terminal rear cover.
2
Insert the RJ-45-type connector of the PIN pad or smart card reader into the
port of the peripheral device.
To install a PINpad 101, PINpad 201, or PINpad 1000, position and insert the
grommet to secure the cable connection.
G
UIDE
A B C