Table of Contents
Advertisement
Ch.2 Unpacking and Installation
Upper Cover
Front
DRYPRO Vstage MODEL 793 Installation Manual Ver.1.00 2004.11
5
Remove the 2 cables on the far side of the
HPRO unit from their clamps.
6
Loosen the 4 screws (Sems 2 M4X8) at the
front and rear of the upper cover (HPRO unit).
7
As shown at left, remove the upper cover
holding the left and right sides.
8
Set the removed upper cover top side down in a
safe place.
9
Remove the 2 screws (TP screws M4X8)
securing the upper opposing rack (one at the
front, one at the back).
< 58 >
The screws securing
the HPRO unit cover
are designed so that
they cannot be removed
even when loosened.
Because the heat roller
removed in step-15 will
be rested on the
removed upper cover,
make sure that the
cover is placed in a
safe location where
there is no risk of it
falling or being
accidentally bumped.
Hide quick links:
Advertisement
Table of Contents
