Table of Contents
Advertisement
Figure 2 Rear view of the HP D2D4106/41 12
1. Power supply cable sockets (two)
2. LAN port 1 (always used for data connection)
3. LAN port 2
4. Management LAN port (Do not use for data)
5. PCI-e slots
Using the ProLiant Guide with HP D2D2502/2504, EJ001C/EJ002C, models
When using the HP ProLiant DL160se G6 guide, be aware of the following HP D2D-specific
information:
The CPU is the Intel Xeon E5520, part number 506013-001. There is one per system.
The HP D2D has four removable hard disks.
There is no optical media storage.
HP D2D2502 Backup System: The configuration of the system memory is 24 GB (3 x 8 GB
DIMMs) for the HP D2D2502 Backup System.
HP D2D2504 Backup System: The configuration of the system memory is 32 GB (4 x 8 GB
DIMMs).
The part number for each 8 GB DIMM is 500662-B21.
The HP D2D is supplied with an HP Smart Array P212 RAID controller (with 512 MB FBWC
module) pre-installed in one of the full-height PCI-e slots. For more information about this card,
search on http://www.hp.com/support/manuals. Part numbers are as follows:
◦
HP Smart Array P212/Zero Memory Controller: 462828–B21
HP 512 MB Flash Backed Write Cache (FBWC): 534916-B21
◦
8
Introduction
6. VGA port for system console monitor
7. USB ports for system console keyboard and mouse
8. RAID controller
9. Fibre Channel card (HP D2D4106fc/41 12)
Advertisement
Table of Contents
Troubleshooting
