4.
Be sure to update the HP D2D software to the latest version. This is done from the Web
Management Interface (Settings/Software page), as described in the HP StoreOnce D2D
Backup System User Guide.
IMPORTANT:
If your replacement flash stick is at a lower revision than the one it replaces,
you may experience a message of "Devices Starting" or "Initialising". This message will also
occur, if the D2D Backup System did not shutdown correctly. In this case, please wait a
minimum of 12 hours before updating software.
Figure 4 HP D2D4312 flash memory module
Figure 5 HP D2D4106 or HP D2D41 12 flash memory module
Replacing the memory module
1 1