Chicco I-Move Instructions For Use Manual page 18

Before installing the child car seat inside the
vehicle, adjust the harness straps to the right
height.
To adjust them correctly, the harness straps must
come out from the backrest at the height of the
child's shoulders (Diag. 26) The child car seat
straps can be adjusted to 3 height positions.
To adjust the harness straps, proceed as fol-
lows:
1. Remove the shoulder pads by unthreading
them through the slots in the fabric cover.
2. Press the red button to open the harness
buckle.
3. Slide the harness straps out from behind the
backrest and thread them though the slot which
is most suitable for the child's height (Diag.
27A and 27B).
WARNING! The booster cushion guarantees
correct containment and the ideal position for
the neck and back of babies from when they are
born until they weigh about 6 Kg.
3.3 FIXED OR ROCKING POSITION OF THE
CHILD SEAT (ROCKER CHAIR MODE)
When the child car seat is not used inside
the vehicle, it can be used as a rocking or static
chair.
To allow it to rock, close the stabiliser block
(Diag. 14) and move the carry handle to posi-
tion C (Diag. 5).
To use it in fixed mode, fold out the stabiliser
block and move the handle bar to position D
(Diag. 5).
Only place the child seat on stable horizontal
surfaces.
WARNING! Before carrying the child car seat,
always bring the carry handle into a vertical
position (B).
WARNING! Never leave your child unat-
tended.
WARNING! Always use the restraint harness.
WARNING! Using the child car seat on raised
surfaces such as tables, chairs etc. can be very
dangerous.
WARNING! This child car seat is not designed
for long periods of sleep.
WARNING! Do not use the seat
when the child is able to sit up on his own.
This child car seat is not a replacement for a bed
or cot. If the child needs to sleep, they should be
moved to a bed or a cot.
Do not use the child seat if some of its parts are
broken or missing.
Do not use accessories, spare parts or com-
ponents that are not approved by the manu-
facturer.
3.4 USE WITH THE STROLLER WARNING!
Please read the Stroller instruction manual when
using the child car seat on the stroller.
WARNING! Use only with Chicco strollers
equipped with the I-MOVE system.
The CHICCO strollers, which use the I-MOVE
system, have special devices that allow you to
fasten the child seat to the stroller without any
need for additional fixtures.
To install the child seat on the stroller, proceed
as follows:
1. Bring the carry handle into a vertical position
(B) (Diag. 28).
2. Connect the two I-MOVE fastener pins on the
child car seat to the stroller, making sure that
both sides are fastened correctly. You will hear
them click into place (Fig. 29).
WARNING!
Before use, ensure that all the child car seat-
fastening devices are correctly fitted in place.
To remove the child car seat from the stroller:
1. Bring the carry handle into a vertical posi-
tion (B).
2. Pull the rear release handle.
3. Remove and place the child car seat on a flat,
stable surface.
WARNING: The child car seat can be fastened
and unfastened with the baby inside; these pro-
cedures could prove to be more difficult due to
the weight of the baby. Be very careful when
performing the above-indicated procedures.
3.5 CLEANING AND STORAGE HOW TO
CLEAN THE FABRIC
COVER
The child seat's fabric cover can be removed
and cleaned by hand or in a washing machine
at 30°C.
To wash it, undo the harness straps, unthread the
two straps and buckle through the relative slots
and then remove the fabric cover (Diag. 30).
18