Parts Supplied; Tools Needed - KitchenAid KUDD03DT Series Technical Education

Gather the required tools and parts before start-
ing installation. Read and follow the instructions
provided with any tools listed here.

TOOLS NEEDED

• Pliers
• Phillips screwdriver
• Flat-blade screwdriver
• 3/16" and 1/4" nut drivers or hex sockets
• Measuring tape or ruler
• 1 1/2 hole saw bit
• 10" adjustable wrench
• Utility knife
• Level
• Electric drill
• 1/8" drill bit
• Security T-20 TORX®† driver (if installing
custom front panels)
PARTS NEEDED
A
A. 60" (152.4 cm) flexible water supply line
B. Zip tie
C. 2 appropriate sized UL listed wire connectors
†®TORX is a registered trademark of Textron
Innovations Inc.

PARTS SUPPLIED

Check that all parts are included.
A
E
M
B
�⁄�
A. " UL listed strain relief
B. 1.25" hose clamp
C
C. 8 mounting bracket screws
D. 4 unit mounting screws
E. Y drain connector
F. 4 mounting brackets
G. Drain connector spring
clamps
2-2
C
B
F
I
G
J
K
H. 2 trim strips
I. Toe kick brackets
J. 2 toe kick bracket screws
K. Toe kick trim
L. 2 panel fasteners (on some
models)
M. 10 TORX screws (on some
®†
models)
D
H
L