Amplify; Voice Announcement - Geemarc SCREENPHONE User Manual

SETTINGS

Amplify

A switch located at the rear allows the amplification facility to be
switched ON or OFF.
Your telephone is pre-set with the Amplify switch at the OFF
Postion.
Amplify Switch at ON Position
The additional amplification and tone controls are automatically
activated each time you use the telephone. The LED light next to
the amplify button will be lit. You can still turn the amplify feature
off at any time, simply press the amplify button on the front of the
telephone.
Amplify Switch at OFF Position
The additional amplification and tone controls are off by default
each time you use the telephone. The LED light next to the amplify
button will not be lit. You can still turn the amplify function on at
any time, simply press the amplify button on the front of the
telephone.
Your telephone is pre-set with amplification switched to OFF and
handset volume to Minimum. See Volume and Tone section in the
Using the Telephone chapter for more detail.

Voice Announcement

A switch located on the right side of the telephone allows the voice
announcement to be switched ON or OFF. The message is a
pre-set factory message; you are not able to change it.
When this function is "ON" the phone will inform people who are
calling on a standard voice telephone, without the 18002 prefix,
that you are using Voice Carry Over or a textphone. It will instruct
them to call again using the prefix 18002. The message is as
follows " Please dial 18002 before number".
If you are new to using Voice Carry Over or Text Relay, and will
not be using this telephone as a standard telephone, it is
recommended that this function is turned "ON". If you are confident
that anyone who calls you will remember the 18002 prefix then this
can be turned 'OFF'.
16