Analog I/O Configuration; Figure 2-6. Interrupt Jumper Setting For Disabling Interrupts - National Instruments Low-Cost Multifunction I/O Board for ISA Lab-PC+ User Manual

Configuration and Installation
If you do not want to use interrupts, place the jumper on W5 in the position shown in Figure 2-6.
This setting disables the Lab-PC+ from asserting an interrupt line on the PC I/O channel.

Figure 2-6. Interrupt Jumper Setting for Disabling Interrupts

Analog I/O Configuration

The Lab-PC+ is shipped from the factory with the following configuration:
• Referenced single-ended input mode
• 5 V input range
• Bipolar analog output
• 5 V output range
Table 2-4 lists all the available analog I/O jumper configurations for the Lab-PC+ with the
factory settings noted.
Lab-PC+ User Manual
• • • • •
• • • • •
3 4 5 6 7
IRQ
2-8
•
•
9
© National Instruments Corporation
Chapter 2