Configuration and Installation
Unipolar Output Selection
You can select the unipolar (0 V to 10 V) output configuration for either analog output channel
by setting the following jumpers:
Analog Output Channel 0
Analog Output Channel 1
This configuration is shown in Figure 2-8.
Analog Input Configuration
You can select different analog input configurations by using the jumper and register bit
(software) settings as shown in Table 2-4. The following sections describe each of the analog
input categories in detail.
Input Mode
The Lab-PC+ features three different input modes–referenced single-ended (RSE) input, non-
referenced single-ended (NRSE) input, and differential (DIFF) input. The single-ended input
configurations use eight channels. The DIFF input configuration uses four channels. These
configurations are described in Table 2-5.
Lab-PC+ User Manual
W1
W2
W1
•
A
B
•
B
•
C
U
Channel 0
Figure 2-8. Unipolar Output Jumper Configuration
B-C
B-C
W2
•
A
B
•
B
•
C
U
Channel 1
2-10
© National Instruments Corporation
Chapter 2