Register Map And Descriptions - National Instruments Low-Cost Multifunction I/O Board for ISA Lab-PC+ User Manual

Appendix D

Register Map and Descriptions

This appendix describes in detail the address and function of each of the Lab-PC+ registers.
Note: If you plan to use a programming software package such as NI-DAQ, NI-DSP,
LabVIEW, or LabWindows/CVI with your Lab-PC+, you need not read this
appendix. Refer to your software documentation for programming information.
Register Map
The register map for the Lab-PC+ is given in Table D-1. This table gives the register name, the
register address offset from the board's base address, the type of the register (read-only, write-
only, or read-and-write), and the size of the register in bits.
© National Instruments Corporation D-1 Lab-PC+ User Manual