Quick Overview Of System Operation - Audio Technica ATW-R1810 Installation And Operation Manual

Quick Overview of System Operation

Thank you for purchasing this Audio-Technica 1800 Series Single-channel Camera-mount
UHF Wireless Microphone System.
primarily to be used with video cameras, with the ATW-R1810 Receiver mounted on a camera
and connected to the camera's audio input; they may also be used with other components
equipped with microphone-level input.
First, insert batteries. ( See Receiver Battery Installation, page 8. )
channel Receiver also functions without batteries if connected to an external power
supply (12V DC source, 500 mA nominal current, not included).
Next, attach the antennas to the antenna input jacks, and mount the ATW-R1810 Receiver to your
camera (mounting hardware not included); or use the included pouch with belt clip to attach the
ATW-R1810 to your belt. Connect the output cable to the ATW-R1810 and your video camera (or
audio mixer). ( See Output callout, page 7 ).
Turn the ATW-R1810 on: Press and hold the Power/Set button until the Power LED lights red.
Select an operating frequency. (S ee Selecting Frequencies on your Receiver, page 9. )
NOTE: Transmitter-Receiver pairs must be set to identical frequencies.
IF your system is equipped with a UniPak
body-pack transmitter your wireless essential microphone (not included). Turn the power on.
Select a frequency and choose other settings. ( See Operating the Transmitter and How to Set
Frequencies on your Transmitter, page 11. )
IF your system is equipped with a Plug-on Transmitter:
condenser) to the Plug-on Transmitter's input connector ( See Microphone Input, page, 10 ). Turn
the power on ( See Operating the Transmitter, page 11 ). Select a frequency and choose other
settings. ( See Operating the Transmitter and How to Set Frequencies on your Transmitter,
page 11. )
All 1800 Series Single-channel systems are designed
Note: The ATW-R1810 Single-
™ Body-pack Transmitter: Plug into the UniPak
Attach a microphone (dynamic or
™
5
E
N