Advertisement
Available languages
Available languages
C
C
A R E A N D
LE A N I N G O F
Blender container parts are corrosion resistant, sanitary and easily cleaned. Before first use
and after every use, separate container parts and clean thoroughly in warm, soapy water,
then rinse and dry well. DO NOT WASH ANY PARTS IN AN AUTOMATIC
DISHWASHER.
Periodically check all parts before re-assembly. If the processing blades are stuck
or difficult to turn, DO NOT USE BLENDER. Check by carefully turning the blades
in a counterclockwise direction (opposite edges are sharp). Blades should turn freely.
If the container is chipped or cracked, DO NOT USE BLENDER. Further use could
result in the container breaking during use. Use only OSTERIZER
recommended replacement parts available at an Authorized Service Center.
USE OF DAMAGED OR NON-RECOMMENDED PARTS COULD RESULT
IN SEVERE PERSONAL INJURY AND/OR DAMAGE TO THE BLENDER.
See Page 4 for proper container assembly and user instructions.
NEVER IMMERSE THE MOTOR BASE IN WATER. The housing can be cleaned
with a damp cloth (unplug first). The motor is permanently lubricated and does not require
any additional lubrication. ANY SERVICING SHOULD BE PERFORMED BY AN
AUTHORIZED SERVICE FACILITY.
H
Y
O
O W
O U R
ST E R I Z E R
®
Your OSTERIZER
Blender is a multi-speed appliance which operates on a wide range
of speeds from very slow to very fast. This range of speeds makes food preparation easy,
interesting and fast.
®
In addition, your OSTERIZER
Blender has two distinct methods of operation:
1.
CONTINUOUS run for blending, liquefying and fine chopping.
2.
CONTROLLED CYCLE BLENDING, used for chopping pieces of food, such as vegetables,
nuts or cheeses. There are several different ways of operating the CONTROLLED CYCLE /
BLENDING CYCLE feature, but all involve turning the motor "ON" and "OFF" intermittently.
When "ON, " food is chopped and tossed away from the blades. When "OFF," the food
is distributed around the blades to make processing more uniform.
N
: A cycle consists of operating the blender for about two seconds and then allowing
OTE
the blades to coast to a stop.
S
F
PEED TO
UNCTION
Y
O
® B
O U R
ST E R I Z E R
LE N D E R
®
Blender
® B
W
LE N D E R
O R K S
C
HARTS (S
P
10)
EE
AGE
6
B
LE N D E R
Mini Jars (8-ounce/250 ml) are available as an accessory and are not normally included
with your Blender. For proper assembly and tightening instructions, see directions above
and on previous page. The Mini Jars allow for the processing and storing of foods in the
same container.
DO NOT USE OTHER TYPES OF JARS FOR PROCESSING FOODS. Ordinary jars
may break or unscrew during processing. Do not wash any parts, including container,
in an automatic dishwasher. DO NOT fill Mini Jar above MAXIMUM FILL LINE to allow
for expansion of foods while processing. Overfilling may cause the jar to break and could
result in injury.
O
® M
ST E R
I N C E R A N D
The OSTER
M
and F
P
®
INCER
OOD
ROCESSOR
is included with some models. The M
INCER
H
T
U
OW
O
SE
Remove Blender Jar and place
onto motor base of Blender. Make sure that the
M
INCER
OSTER
®
logo faces front, and that the holes under the base match the Blender spikes.
Remove cover by pushing it down and rotating it counterclockwise. Insert the blade,
and put the ingredients to be minced into the container of your OSTER
Replace the cover by pushing it down and rotating it clockwise, making sure that the
three locks are correctly secured and that the OSTER
while using your M
, press down on the cover of the OSTER
INCER
After using your OSTER
®
M
, remove parts and wash each in water.
INCER
Dry immediately or let air dry.
A
CC E SS O R I E S
M
J
I N I
A R S
F
P
O O D
R O C E SS O R
is available as a stand-alone accessory and
is designed to mince virtually all foods.
®
M
INCER
logo is in front. For safe operation
®
M
during operation.
®
INCER
7
.
Advertisement
