Table of Contents
Advertisement
Settings Modified for Networking
Parameter
Description
Address
Options
Trunk Settings
Parameter
Description
Programming FF1 8# 4# 6# (1-64)# 1# (0-4)#
Options
Extension Settings
Parameter
Description
Programming FF3 (1-144)# 1# (10-69, 100-699, N100-N699)#
Options
Page 82
SMDR Printing Mode 1: Outbound and Inbound
(Modified to add a setting to include Network Calls)
Specifies the call types to be included in SMDR.
FF1 2# 2# 6# (0-2)#
0=Outgoing Only
1=Incoming and Outgoing
2=Incoming, Outgoing, and Network
T1 Trunk Type
(Type 4 - E&M Network trunk type added)
Determines the type of trunk signaling that each T1 channel
emulates.
Note: For changes to this parameter to take effect, the
system must be powered down, then back up again.
0=Loop start
1=Not used
2=Ground start
3=E&M
4=E&M Network
Extension Numbers
(Modified to allow for 4-digit numbers)
This program assigns an extension number to an extension
port.
N=DBS network node number 1-4
T1 Networking-Revised April 2000
Programming
DBS-2.3/9.2-540
Advertisement
Table of Contents
