Operation - GBC H420 Instruction Manual

Introduction
Thank you for purchasing this GBC
heats up to operating temperature quickly and retains its heat so you
can laminate your documents without waiting. The laminator also
provides cold lamination for cold lamination pouches. The laminator
provides audible and visual indication that it is ready to laminate. The
laminator goes into a standby mode after 30 minutes of inactivity.
Please take a little time to study these instructions to ensure you get the
best out of your machine. Your new laminator may emit a slight odour
during the initial operation. It is normal and will diminish after a few
hours of operation.
Transportation tabs
Before use, the transportation tabs must be removed (fig. 1).
Carefully peel away the tape.
1
Pull the tabs inward to free them.
2
Remove the tabs.
3

Operation

1 Connect power cord to appropriate power source.
For cold lamination, push the power button to turn on the machine.
2
The indicator will glow (fig. 2). Skip step 3.
For hot lamination, select the button for the appropriate pouch
3
gauge thickness. The button will blink until it is ready. (fig. 2).
4 Position the document to be laminated into a GBC laminating pouch,
so that the document is aligned to the folded sealed edge and the
right and left borders are equal (fig. 3).
When the ready light turns on (fig. 4) and the machine beeps, insert
5
the pouch and its contents straight into the machine, leading with
the folded sealed edge (fig. 5).
The laminated item will automatically exit the rear of the machine.
6
7 You can select a different pouch thickness. If you select a lower
setting, the laminator must cool down to that setting before
laminating. The ready light will glow when the laminator is ready.
If you have finished laminating, push the power button to turn off the
8
machine (fig. 2).
Guarantee
Operation of this machine is guaranteed for two years from date of
purchase, subject to normal use. Within the guarantee period, ACCO
Brands Europe will at its own discretion either repair or replace the
defective machine free of charge. Defects due to misuse or use for
inappropriate purposes are not covered under the guarantee. Proof
of date of purchase will be required. Repairs or alterations made by
Register this product online at www.accoeurope.com
Pouch Laminator. The laminator
®
Jam Free feature
This machine is equipped with GBC SureFlow anti-jam performance
which will prevent laminating pouches from jamming when used in
accordance with this instruction manual and when using GBC branded
pouches.
• If you experience a pouch jam, place one hand on the machine and
gently pull the pouch out the front of the machine with your other
hand (fig. 6).
• Do not reuse the same pouch.
• Load a new pouch and review the Operation section of this manual.
Cleaning
m
Caution: Unplug this product before cleaning the exterior. Wipe
exterior only with a damp cloth and do not use detergents or
solvents. Your laminator came with a cleaning card that is to
be used after each laminating session, prior to shutting off the
machine. Adhesive may exit the pouch and stick to the rollers
while laminating or if a jam occurs. The cleaning card removes
this residue, keeping your machine in proper working order and
extending its life.
Run the cleaning sheet through the machine two or three times.
1
Turn off the machine when finished laminating and cleaning.
2
persons not authorised by ACCO Brands Europe will invalidate the
guarantee. It is our aim to ensure that our products perform to the
specifications stated. This guarantee does not affect the legal rights
which consumers have under applicable national legislation governing
the sale of goods.
G
5