Table of Contents
Advertisement
OPERATION
This chapter describes how to use the laminator to:
•
Operate the machine
•
Load films (web the machine)
•
Laminate items
•
Mount items
GENERAL OPERATION
Fig. 6-1. Control Panel
© 2006 General Binding Corporation
These instructions assume that the films have been loaded.
For information about loading films, see the Loading Film
section in this chapter.
A. SPEED ADJUSTMENT (Figure 6-1)
B.
LED
C. RUN
A
D. STOP
B
E.
REVERSE
To run the laminator
1.
Turn the laminator On (I) with the power switch
located at the back of the machine.
C
WARNING: Make sure the print clamp
(Artic Titan 1064 WF c) and feed trays are in
their proper positions. Your fingers and hands
could be trapped and crushed in the rollers.
D
Clothing, jewelry, and long hair could be caught
in the rollers and pull you into them.
E
2.
Set the roller pressure handle for the thickness of
the item that is to be laminated or mounted.
3.
Set the desired speed on the control panel.
4.
Press RUN or the Foot Switch. The rollers will
begin to turn.
5.
Position the item(s) to be laminated or mounted
on the feed table.
6.
Push the item(s) squarely into the roller nip point
(where the two rollers meet). Additional items
can be laminated or mounted without stopping
and starting the machine.
7.
Release the foot switch or press STOP to stop the
laminator when all of the items have completely
exited the rear of the machine.
14
Page
Advertisement
Table of Contents
