Table of Contents
Advertisement
Operating Instructions
6. O
PERATION
This chapter describes how to use the laminator to:
•
Operate the machine
•
Load films (web the machine)
•
Laminate items
•
Mount items
G
O
ENERAL
PERATION
These instructions assume that the films have been
loaded. For information about loading films, see the
Loading Film section in this chapter.
Power switch
Fig. 6-1. Power Switch on the Back of The Machine.
Fig. 6-2. Roller Pressure Handle.
To run the laminator:
1.
Turn the laminator On (I) with the power switch
located at the back of the machine.
WARNING: Make sure the safety shield and
feed tray are in their proper positions. You could be
burned and your fingers and hands could be trapped
and crushed in the hot rollers. . Clothing, jewelry, and
long hair could be caught in the rollers and pull you
into them.
2.
Set the roller pressure handle for the thickness of
the item that is to be laminated or mounted.
READY
TEMPERATURE
220
BOTTOM
TEMP
HEAT
ON
OFF
MEAS.
Fig. 6-3. Control Panel.
3.
Do any of the following.
a.
If using thermal films, turn on the bottom
heat if needed, and then use the TEMP
up or down buttons to set the desired
temperature.
b.
If using PSA films, go to the next step.
44DT
SPEED
9
°F
SPEED
FAN
REVERSE
RUN
STOP
Page 6-1
Advertisement
Table of Contents
